Toshiba PORTEGE R200 Replacement Procedures page 67

4.27 Fluorescent Lamp
2. Assembling the cell with the PCB
1) Illuminate the backlight.
2) Make sure there is no scratch or dirt on the backlight. Also check the back of the
cell. Next, install the cell with the PCB to the backlight unit.
CAUTION: 1) Install by aligning the left under corner as shown below.
2) Be careful not to damage the FPC.
PORTEGE R200 Maintenance Manual (960-519)
Figure4-44 Replacing TMD lamp(7)
4 Replacement Procedures
Cell with PCB
[CONFIDENTIAL] 4-61