TOSHIBA
3) 1:N RIO connection
This is a connection made via Integrated Controller V Series.
The PC is connected to the Integrated Controller network and exchanges messages with the
Integrated Controller RIO (Remote I/O Controller).
RIO and drive equipment exchange messages using the message transmission function of
the Transmission Unit TL-S20. Consequently, the PC exchanges messages with the drive
equipment.
In this case, an IP address is required for the PC and each RIO.
The drive equipment does not need an IP address because message is exchanged using the
TL-S20.
RIO
TL-S20
ASC
250Wi
T-250Wi
Figure 2.3 RIO connection
- 4 -
Ethernet
RIO
TL-S20
ASC
T-250Wi
250Wi
6F3A4508