Draining The Water - Honeywell TP-COMPACT-WK User Manual

USE & OPERATION (CONTINUED)

DRAINING THE WATER

WARNING: Always drain and discard water collected from dehumidification.
The water is not clean and cannot be used for drinking.
1. Draining water collected in the Water Tank
The condensed water can be collected directly into the Water Tank. When the Water Tank is full, the
dehumidifier will automatically shut OFF and the
panel followed by a beeping sound.
IMPORTANT: Do not move the dehumidifier when the Water Tank is full as it may heavy and can
cause water spillage.
1.1 Locate the Water Tank at the front of the dehumidifier.
Gently pull the water tank out.
1.2 Carry the Water Tank to a sink to empty.
1.3 Replace the empty Water Tank back into the front of
the dehumidifier. Please make sure that the tank is
properly positioned. The safety feature ensures that
any misalignment of the tank and the unit will prevent
the unit from turning back on.
IMPORTANT: Improper alignment or positioning of the
Water Tank will cause the unit to pause operation, the
warning light on top of the dehumidifier will illuminate
followed by a beeping sound, until the Water Tank is fitted
properly.
NOTE: There is a Float inside the Water Tank that senses
the water level to automatically stop dehumidification when
the Water Tank is full. Make sure the Float is positioned
correctly inside the Water Tank by ensuring it lies level with
the top edge of the Water Tank.
DO NOT REMOVE THIS FLOAT.
indicator will illuminate on the control
1.1
1.2
EN 13
Float