Table of Contents
Advertisement
It is strongly recommended that you save the device's memory data to
your computer or a storage card. The manufacturer is not responsible
for data changed or lost due to battery discharge. For back up, see
"Backing Up" on page 137.
Initial Setup
When using your device for the first time, completely charge the battery
then follow the initial setup procedures below:
Press the Power button and when the welcome screen appears, tap the
1.
screen with the stylus to start the setup process.
When the align screen appears, follow the directions for adjusting the
2.
touch screen until the stylus screen appears.
If a finger or any other object touches the screen during a correction,
it will be cancelled. Repeat the correction procedure.
Note:
To display the align screen after the initial setup process, press
the Record button while pressing the center of the navigation button, or
Settings
System
by tapping
,
,
Read and understand how to use the stylus, then tap
3.
Note:
See "Using the Stylus" on page 19 for more information.
Read and understand pop-up menu operation, then tap
4.
Read the on-screen explanation and then operate the screen.
Display the pop-up menus, and cut and paste the data according to
the screen instructions. When this stage is complete, tap
Follow the directions for setting the location, then tap
5.
When the complete screen appears, initial setup is finished. After
6.
tapping the screen, the Today screen will appear and the device will be
ready to use. See "Today Screen" on page 28 for more information.
Slide the Radio Standby Switch on the left side of the device to the upper
7.
side (ON) to activate the phone function.
Section 2: Understanding Your Device
24
2A: Your Device - The Basics
Screen
, and then
.
.
Next
.
Next
.
Next
.
Next
After power up is completed, use the stylus to tap on the
8.
menu at the bottom of the screen, and select
device has not yet been activated, the Activation Wizard will
automatically start when you turn on the radio in your device.
Tap
three times.
9.
Next
On the fourth screen, you will be prompted for a lock code. Use the
10.
keypad to enter the 6-digit lock code given to you by the Sprint
Customer Solution representative, then tap
Enter the mobile phone number given to you by the Sprint Customer
11.
Solution representative, then tap
Next
Tap
on the last screen, and the device will begin to initialize using
12.
Next
the data you have just entered.
Section 2: Understanding Your Device
pull-up
Admin
. If your
Activation Wizard
.
Next
.
2A: Your Device - The Basics
25
Advertisement
Table of Contents
