TEC MA-1595-1 Series Owner's Manual page 14

5. DISPLAY
(3) Error Messages (in any mode except "LOCK")
When an error occurs, an error message (programmable) is displayed, with an error buzzer generated (a long
tone).
X X X X X X X X X X X X X X X X
Read the Error Message, depress the [C] key to cancel the error status and tone, operate the sequence again
after removing the cause of the error.
The following table shows the cause of the error.
If the error status cannot be cancelled or an error message not listed in the table below is displayed, please
contact your nearest TOSHIBA TEC representative.
Error Message
(Standard Setting)
OPERATION ERROR
MANAGER REQUIRED
CLOSE DRAWER
COMPULSORY CODE
COMP DEPOSIT
SCALE REQUIRED
SCALE OUT
PC COMM ERROR
CODE ERROR
PROGRAM ERROR
CALL MANAGER
DRAWER LIMIT
LINK PLU ERROR
COMPULSORY SLIP
CDV ERROR
COMP CHECK NO.
X/Z IN PROGRESS
ALREADY RESERVED
UNDER AGE
COMP QUANTITY
PIN ERROR
NO RESPONS
RECEIPT REQUIRED
RESPONS NG
MISC ERROR
PAPER END
16 15 14 13 12 11
Error Message (max. 16)
ERROR MESSAGE TABLE
Key Sequence or Operation Procedure Error
The operation requires a Manager Intervention.
The drawer must be closed before the operation.
No code has been entered where it is compulsory.
Sub-link Department is compulsory, but not yet entered.
The [SCALE] key has not been depressed where required.
The scale is malfunctioning.
File Receive Error (when a PC is connected).
An undefined code has been entered, or the entered code has already been
defined.
An additional entry of new PLU or new customer file is not acceptable,
because the memory of each table is full.
The card is not acceptable as a result of Negative Card checking.
A media pick up operation is now required.
PLU linkage error such as when a sub-link PLU is not programmed in the Link-
PLU Table.
The operation requires a endorsement print.
Check Digit Value Error
Performing the negative card check is necessary before finalizing a sale by a
media key which has the compulsory status of the negative card check.
Read/Reset operation is unavailable during the consolidation of the
communication buffer by PC (or master terminal).
Read/Reset/Reserve operation was attempted when reset data remained in
the communication buffer. (in case of the program option to prohibit rewriting
reset data in the communication buffer)
Underage person has attempted to buy cigarette or alcoholic beverage.
Quantity Entry Compulsion Error (when this compulsion status is programmed
to a PLU item).
EFT Pin Pad Error
Time-out condition on the EFT terminal
Entry of new sale transaction is attempted before issuing the store receipt.
Communication error between the ECR and the EFT terminal.
Other errors
Paper is out.
10 9 8 7 6 5
Cause of the Error
5- 3
5.1 Upper Row (16-digit dot windows)
4 3 2 1
EO1-11152