Single lever widespread kitchen faucets (12 pages)
Summary of Contents for Delta CASSIDY 4297-DST Series
Page 1
Escriba aquí el número del modelo comprado. Inscrivez le numéro de modèle ici. You may need/Usted puede necesitar/Articles dont vous pouvez avoir besoin: For easy installation of your Delta faucet you will need: ® • To READ ALL the instructions completely before beginning.
Page 2
à compter de la date d’achat. Aucune pour toutes les demandes en vertu de la garantie, sauf si le produit a été enregistré auprès de Delta garantie ne couvre les piles.
Page 3
RP51784 O-Ring Anillo O Joint torique RP71543▲ RP72751▲ Soap Dispenser (optional) Spray & Hose Assembly Dispensador de jabón (opcional) Ensamble del Rociador RP10345 Distributeur de savon (facultative) y Manguera O-Rings (3) Douchette et Tuyau Anillos O (3) Souple Joints torique (3) RP47888 RP72752▲...
Page 4
OPTIONAL / OPCIONAL / FACULTATIVE Mount Faucet to Deck Optional Escutcheon Installation Your faucet is designed for a hole Secure faucet to sink with washer and mounting For optional installations using the 10 1/2" escutcheon, diameter of 1 3/8" +/- 1/4" (35 mm +/- 6 nut (1).
Page 5
Side Spray Installation Recommended sink hole diameter for side sprayer installation is from hose assembly (5) and discard if installing a side spray. Keeping the 1 1/8" (28.4 mm). Recommended spacing between holes for faucet and diverter clip pulled out, insert spray hose nipple (6) into hose assembly sprayer is 4"...
Page 6
Loop tubing created. Delta is not responsible for tubing that is l Tubing is cut too short: buy a coupling union and a (2) if it is too long. Note: Recommended tubing...
Page 7
Correct method Incorrect Installation Instalación Incorrecta Método Correcto Installation Incorrecte Bonne méthode Do not install sleeve Ensure cut is straight. upside down. No instale la manga Asegúrese que el corte boca abajo. esté recto. Custom Fit Connections - Plastic Sleeve Installation Instructions 1.
Page 8
Maintenance If faucet leaks from under handle or from spout outlet – Insert a small screwdriver into slot (1) in button (2) and remove. Loosen set screw (3) inside of handle. Remove handle. Remove cap (4) by rotating counterclockwise. Bonnet may be stiff due to O-ring, but should rotate by hand. Remove bonnet nut (5) by rotating counterclockwise with a wrench.