BN Thermic SCHG-30E Instructions

Thank you for purchasing a BNThermic product. Manufactured to a high standard, this product will, if used according to these
instructions and properly maintained, give you years of trouble free performance.
REGISTER: PLEASE REGISTER THIS PRODUCT ONLINE TO ACTIVATE YOUR GUARANTEE AT
IMPORTANT: PLEASE READ THESE INSTRUCTIONS, NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS, AND CAUTIONS.
USE THIS PRODUCT CORRECTLY, AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY
CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY.

1. SAFETY INSTRUCTIONS

1.1 ELECTRICAL SAFETY

WARNING! It is the responsibility of the owner and the operator to read, understand and comply with the following:
You must check all electrical products, before use, to ensure that they are safe. You must inspect power cables, plugs,
sockets and any other connectors for wear or damage. You must ensure that the risk of electric shock is minimised by the
installation of appropriate safety devices. A Residual Current Circuit Breaker (RCCB) should be incorporated in the main
distribution board. If in any doubt consult a qualified electrician.
You must also read and understand the following instructions concerning electrical safety.

The Health & Safety at Work Act 1974 makes owners of electrical appliances responsible for the safe condition of those
appliances and the safety of the appliance operators. If in any doubt about electrical safety, contact a qualified electrician.

Installation should always be carried out by a qualified electrician or a competent person in accordance with current
electrical regulation.

Ensure that the insulation of all the cables on the appliance is undamaged and safe, before connecting it to the power
supply.

Ensure that the cables are always protected against short circuit and overload.

Regularly inspect the power supply cables and plugs etc. for wear or damage and check all connections to ensure that none
are loose.

Important: Ensure that the voltage marked on the appliance matches the power supply to be used and that a correctly rated
fuse is fitted.

DO NOT use worn or damaged cables, plugs or connectors. Immediately have any faulty item repaired or replaced by a
qualified electrician.

The unit should be protected by a suitably rated isolator and fuse or MCB.

This heater is IP20 rated and is suitable for indoor or under cover use
only.

Do not attach this heater to an extension cord it must be hard wired in
position.

1.2 GENERAL SAFETY INSTRUCTIONS


Remove all packaging and store it away from children, check the
package and heater for visible damage or tampering.

Familiarise yourself with the applications and limitations of the heater.

Ensure the heater is in good order and condition both physically and
electrically before use. If in any doubt, do not use the unit and contact
your supplier.

Only use recommended attachments and parts. To use unauthorised
parts may be dangerous and will invalidate your warranty.

Keep tools and other items away from the heater when it is in use.

Keep children and unauthorised persons away from the heater, as it gets
hot.

Disconnect from mains and allow to cool before attempting any cleaning
or maintenance.
X DO NOT use in areas where hazardous gasses or dusts may be
present.
X DO NOT locate the heater directly below the power outlet.
X DO NOT disassemble the heater for any reason. This heater must be
checked by qualified personnel only.
X DO NOT use this heater to perform a task for which it has not been
designed.

WARNING! Ensure you observe the safety distances and mounting
heights and there is no possibility of inflammable materials coming into
contact.
INSTRUCTIONS FOR:-
600 x 600 CEILING GRID HEATER
SCHG-30E
www. .co.uk
bnthermic