Advertisement
Notice
u This user manual is used to install and maintain GNE
power optimizer models Honeybee 350/400, Honeybee
700/800, PV monitor model Scouter350/450 and data
processing devices.
u No permission to disassemble and repair the products
to ensure the safety of personnel. For services, please
look for trained or qualified professionals.
u Before installing and using the power optimizers,
please familiarize yourself with all the tips and warnings
on the products, as well as the safety instructions and
other applicable safety guidelines in the inver ter
manual and the PV module installation instructions.
u To reduce the risk of fire and electric shock, install the
power optimizers in strict accordance with local
electrical standards and codes.
u I n s t a l l a t i o n m u s t b e p e r f o r m e d b y a t r a i n e d
professional. GNE is not liable for any loss or damage
caused by improper operation, discomfort or misuse of
these products.
u Before installing the optimization and monitoring
products, please remove all metal accessories that you
wear to reduce the risk of touching live circuits. It is
strictly forbidden to install and debug in bad weather.
u Do not operate if the GNE products can be physically
damaged. Check existing cables and connectors to
ensure they are in good condition and status. Do not
operate the cables and connectors of GNE products if
they are damaged or unqualified.
u D o n o t c o n n e c t o r d i s c o n n e c t t h e G N E p o w e r
optimizers and montoring products under load. There
is also a risk of electric shock when shutting down the
inverter or the GNE products. After disconnecting all
power supplies, the capacitor inside the inverter can
continue to charge for a few minutes. Before measuring
the line, first measure the voltage at the inverter and
confirm that the capacitor is no longer charged.
u Before the GNE customer service personnel provide
services, please make sure that the data aggregation
device Beehive is powered on and the internet is fine,
and optimizers work in power-on status, then check the
current, voltage and power of the PV series.
Advertisement
