Tcp/Ip Configuration - Toshiba E1-17063A Operator's Manual

Digital plain paper copier
Table of Contents

Advertisement

2. TCP/IP CONFIGURATION

This section describes the procedures to configure the TCP/IP for the Network Interface Card to connect
to the Internet.
The items and the parameter values for the TCP/IP Configuration Setup are dependent on if the IP
address of the device is obtained from a DHCP server or assigned manually.
Item
BootP/DHCP
IP Address
Subnetmask
Default Gateway
3
Host Name
• BootP/DHCP
Set to enable or disable the BootP/DHCP whether obtaining the IP address from the DHCP server.
When the TCP/IP settings of this machine are provided by the DHCP server, set this to ON. Set the
BootP/DHCP to OFF when you want to assign the TCP/IP settings manually.
• IP Address
Assign the IP address of this machine. Do not set this when the IP address is obtained from the DHCP
server. The machine uses the IP address here even if the BootP/DHCP is set to be enabled.
• Subnetmask
Assign the Subnetmask if required.
• Default Gateway
Assign the Default Gateway address when the machine is used in the network through a router.
• Host Name
Set the FQDN of this machine. This name is used as the sender name for E-mails.
Note
When you want to set to SMTP for the Receive Mode, the IP address must be assigned manually.
3-4
SETUP
Use DHCP Server
Set to ON
Not required
Not required
Not required
Required
Assign IP Address
Set to OFF
Required
Required if necessary
Required if necessary
Required

Advertisement

Table of Contents
loading

This manual is also suitable for:

E-studio 16E-studio 20E-studio 25

Table of Contents