Lennox G32V Series Service Literature page 76

(continued from previous page)
G32V−4 OPERATION SEQUENCE AND JUMPERS SUMMARY WITH VSP3 (COOLING CONTINUED)
T−STRIP JUMPER
MATCH UP
FOR HEATING JUMPERS
SEE HEATING SECTION
ABOVE
Remove the
CCB1 with Single-Speed
factory−wired
Compressor, no Harmony
CCB1 with Two-Speed
Compressor, no Harmony Remove jumper
from Y1 to DS
(continued on following page)
COMMENTS OR SEQUENCE
Blower speed is controlled
Y1 to Y2
by the DC signal from
and
CCB1. Blower operates on
O to R
low speed during
dehumidification.
Otherwise, blower operates
jumper
on high speed during
Y1 to DS.
cooling cycle.
O to R
See table 14.
and
Y1 to Y2.
WIRING CONNECTIONS
Y
1
Y
2