Dell PowerConnect M6220 Series Getting Started Manual page 11

Connect the USB type A connector on the USB cable directly to the switch USB console port.
3
The PowerConnect M6220 series USB console port is located on the left side of the rear
panel, as shown in Figure 2.
NOTE:
If you are installing a stack of switches, connect the terminal to the Master Switch. When a stack
is powered up for the first time, the switches elect the Master Switch, which may occupy any location in
the stack. If you connect the terminal to a member switch, you will not be able to use the CLI.
Figure 2. Connecting to the Console Port
latch closed
latch open
9
Getting Started Guide