16 INSTALLATION
4
Place the door onto the lower hinge pin.
Bottom hinge
Caution
• When lifting the hinge free of the latch, be careful
that the door does not fall foward
• Place the door, inside facing up, on a nonscratching
surface. Be careful not to damage the water lines.
NOTE
• Do not remove the grease on the surface of the gasket or
hinge.
• Do not remove the sensor assembly in the rigth upper
hinge cover.
Assembling the Freezer Door
Left Door
1
Lower the door over the middle hinge pin.
2
Make sure the door is aligned with the
interior cabinet.
3
Place the top hinge on the bra of the Hinge lever
and in place. Turn the lever clockwise and adjust
the hinge.
Disassembling / Assembling the Water Lines
Tube
Insert lines
4
Gently press the collet and insert the tube until only one line
shows on the tube.
(Correct)
NOTE
• Water hoses should be cut with a clean, straight edge
to avoid leaks.
5
Fit the top over the hinge lever latch and into place.
Rotate the lever clockwise to secure the hinge.
6
Install the grounding screw and connect all the
wire harnesses.
7
Push the water supply tube into the hole from the top of
the cabinet and pull it through the back plate.
8
Reconnect the water tubes by inserting the tubes
into the connectors. The tube is inserted correctly
when only one guide line is showing out of two.
Collet
Tube
(Incorrect)