Steam Ironing; Dry Ironing; Vertical Steaming - Russell Hobbs Easy Store Instructions Manual

h STEAM IRONING
24 If you intend to use steam, the temperature setting must be S or higher.
25 If you don't, you'll get water on your clothes, not steam.
26 Set the steam control to the setting you want (S = no steam, # = high).
27 Wait till the light goes off, then start ironing.
k SPRAY
, Water spotting affects some fabrics. Test this on a hidden part of the fabric.
28 This function works with dry or steam ironing, as long as there is water in the reservoir.
29 Lift the iron off the fabric.
30 Aim the spray nozzle at the fabric.
31 Press the * button.
32 You may have to press it 2 or 3 times to pump water through the system.
j SHOT OF STEAM
33 This function works with dry or steam ironing, as long as there is water in the reservoir.
34 If you intend to use steam, the temperature setting must be S or higher.
35 Lift the iron off the fabric.
36 Press the # button.
37 You may have to press it 2 or 3 times to pump water through the system.
38 Leave 4 seconds between shots, to let the steam build up.
n DRY IRONING
, If you're going to be dry ironing for 20 minutes or more, empty the reservoir first, to avoid
spontaneous bursts of steam.
39 Set the steam control to S.
40 Wait till the light goes off, then start ironing.
l VERTICAL STEAMING
41 Remove wrinkles from hanging clothes, hanging curtains, and furnishing fabrics.
42 Check that there is adequate ventilation behind the fabric, otherwise moisture may build up,
causing mildew.
43 Check that there is nothing behind the fabric that may be damaged by the steam.
44 Check that pockets, turn-ups, and cuffs are empty.
45 Check that there is water in the reservoir.
46 Set the temperature control to max. Set the steam control to S.
47 Lift the iron off the fabric.
48 Press the # button.
49 You may have to press it 2 or 3 times to pump water through the system.
50 Leave 4 seconds between shots, to let the steam build up.
C CARE AND MAINTENANCE
51 Set the temperature control to •. Set the steam control to S.
52 Unplug the appliance.
53 Gently pull the cover out of the water inlet, and let it hang to the side.
54 Hold it over a sink, turn it upside down, and drain the water from the reservoir, via the water
inlet.
55 Replace the cover in the water inlet.
56 Sit the iron on its heel.
57 Leave it to cool down completely.
58 Clean the outside surfaces of the appliance with a damp cloth.
59 Remove spots from the soleplate with a little vinegar.
60 When it's cold, wipe off any moisture, and wind the cable round the heel.
61 Put the plug into the rear of the heel.
4