Rfc 1483 Routed Mode; Ppp Over Atm And Ppp Over Ethernet - Topcom Xplorer 870 Installation Manual

Xplorer 870
Note: To save the settings, please select "Save Configuration" and then click " Save".

8.2 RFC 1483 Routed Mode

Select RFC1483 Routed Mode to change the router to function in RFC1483
Routed connection mode.
Parameters
VPI
VCI
Wan IP address
Subnet Mask
NAPT
Consult your service provider for the related IP information for the WAN connection
including IP and Subnet Mask.
To set the VPI/VCI/WAN IP/WAN Subnet Mask parameters including adding,
modifying and deleting, refer to "Setup VPI/VCI " in Configure RFC 1483 Bridged
Mode.
NAPT should be enabled in this mode!
Note: To save the settings, select " Save Configuration" and then click " Save".

8.3 PPP over ATM and PPP over Ethernet

Select PPPoA Mode button to use PPP over ATM connection mode or PPPoE
Mode button to use PPP over Ethernet connection mode. Your Internet Service
Provider (ISP) will tell you the values of VPI/VCI to use after you sign up the service.
In Annex A of this manual you can find some country settings.
Setup WAN Connection
The Wan connection setup comes with the following parameters:
Description
Virtual path identifier
Virtual circuit identifier
Selected PVC's IP address
Selected PVC's Subnet Mask
Network Address Port Translation
85 85 85 85 85 85 85 85 85 85
Default Value
N/A
N/A
N/A
N/A
ON