Table of Contents
Advertisement
Unfolding the wheelchair
Tip the wheelchair slightly to one side so that
the load is taken from one driving wheel. Then
GB
with your other hand push one of the seat tubes
downwards - the wheelchair unfolds.
Let the wheelchair go again so that it rests on all
four wheels. Now press both seat tubes into the
latches (pressure on both tubes is only necessary
whilst the wheelchair is new; once the folding
mechanism is running smoothly, pressure on one
seat tube will be sufficient).
Fitting the leg supports
Introduce the plastic pegs of the leg support into the top opening of
the frame as far as the stop, holding the leg support at a right angle to
the side frame. Rotate the leg support forwards until it engages and is
positioned parallel to the side frame. Repeat for the second leg support.
The footrest can now be folded down.
Folding the whleechair
If you have a seat cushion, remove it. Fold up the
footrest. Now hold the seat cover at the front and
the back and pull it upwards. This unlatches the
seat tubes and the wheelchair folds up.
Removing the leg supports
Pull the release lever back and swing out the leg
support simultaneously to an angle of 90° to the
side. The leg support can then be removed by
pulling it upwards. Repeat the procedures for the
second leg support.
Rear wheels: Assembly and removal
When necessary, you can reduce the bulkyness of your wheelchair even
further by removing the backwheels. The "Quick Release" floating axles,
considerably simplify this operation.
Assembly
Release the brakes. Hold the wheel around the
hub, through the spokes with one hand. Press the
axle knob with your thumb and slide the wheel
into the axle plate socket until the stop. Release
the button - the backwheel is installed.
28
Footplate
Palette
repose pieds
Adapter sleeve
Palier de roue
Advertisement
Table of Contents
