Isdn-Pri Expansion Card / G.703 Expansion Card - BinTec X4100 Installation Manual

2
Installation of the Expansion Card and Resource Card(s)
2.2.2 ISDN-PRI Expansion Card /
G.703 Expansion Card
The ISDN-PRI card can be fitted with a maximum of two resource cards with
digital modems.
Proceed as follows:
Take the resource card out of the antistatic bag.
2
1 First resource card with digital
modems
2 Spacer pins
Figure 2-6: First resource card with digital modems with ISDN-PRI card
Mount the spacer pins (if not pre-assembled) on the expansion card (see
figure 2-6, page
Phillips screw, fix the screw from below up through the expansion card, and
then mount the spacer pins.
Place the first resource card down onto the corresponding connector (see
figure 2-6, page
Fasten the resource card by fixing the included screws into the spacer pins.
If necessary, connect the second resource card from above onto the sec-
ond connector (see
30 BinTec Access Networks GmbH
4
2
30): Place a washer from above onto the corresponding
30).
figure 2-7, page
3
2
3 Connector for first resource
card
4 Screws
31).
4
1
2