Target Group - Pro-Line System CS300FU Operating Instructions Manual

1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
~
·".
Contents
Key to symbols
General safety instructions
Overview of products
Frequency Converter
lnitial Operation
Programming with the LCD monitor
Navigator (LCD monitor only)
Overview of functions
Error messages and rectification
Technical data
EU Declaration of Conformity
Appendix
Danger of personal injury!
The safety instructions must be observed!
Warning! Danger to property!
The safety instructions must be observed!
Information
Special information
OR
Reference to other sources of information
2
2
2
3
5
8
13
14
16
24
26
26
27
Guarantee
The function and safety of the equipment is only guaranteed
if the warning and safety instructions included in these opera-
ting instructions are adhered to.
The produ cer is not liable for any personal injury or damage
to property that occurs as a result of the warning and safety
instructions being disregarded.
Using the equipment for its intended purpose
The
es
300 FU controls are designed only for
controlling gates and doors with digital end position systems
and integrated frequency converters. It is only permitted to
operate the equipment in dry rooms.
Target group
Only qualified and trained electricians may connect,
program me and service the controls.
Qualified and trained electricians meet the following
requirements:
- knowledge of the general and specific safety and accident
prevention regulations,
- knowledge of the relevant electrical regulations,
- trained in the use and care of appropriate safety equipment,
- capable of recognising the dangers associated with
electricity.
lnstructions for installation and connection
-The controls must be disconnected from the electricity supply
before carrying out electrical works. After the disconnection
there will be a residual voltage. Therefore a safety period
of 180 seconds must be adhered to. During the works the
electricity supply must rema in disconnected.
- Local protective regulations must be complied with.
- Mains cables and control cables must be laid separately.