Advertisement
Quick Links
Advertisement
Related Manuals for polyga HDI Carbon
Summary of Contents for polyga HDI Carbon
- Page 1 HDI Carbon Quick Start Guide...
- Page 2 • Physical capturing unit for capturing 3D data (some assembly is required) Downloading FlexScan3D Software The HDI Carbon 3D Scanner is powered by FlexScan3D. You can download the softw are from the Polyga Accounts Page (https://www.polyga.com/my-account/downloads/ ) or by contacting your distributor.
- Page 3 Congratulations on purchasing the HDI Carbon 3D Scanner. Here are the steps to set up the capturing unit for 3D data acquisition. In this tutorial the HDI Carbon R3x 3D Scanner was used. There are slight variations to the instructions depending on which model you have purchased.
- Page 4 Tripod Setup Simply open the tripod legs and place them firmly on the ground. Attach the tripod head to the legs by firmly twisting the tripod head until it is hand tight. (Some scanners will arrive with the tripod head already attached.) Connect the Scanner to the Tripod Carefully lift your scanner and locate the mount adapter.
- Page 5 Attach Cameras to the Mounts Depending on the model of the scanner, the camera brackets will come in varying sizes and configurations. For the most part, this will not affect the scanner’s assembly. In most cases, the camera mounts will arrive pre-assembled. If that is the case, you can safely skip to the next step.
- Page 6 Attach the camera brackets onto their scanner mounts. Ensure that the metal pin is in placed between the bracket and mount, allowing the camera to rotate. Tighten the screws until they are firm, but do not over tighten. Small Cameras Attach Camera Mounts to the Scanner Attach the mounts onto both sides of the scanner.
- Page 7 Small Cameras Attach the Lenses to the Cameras Carefully remove the lenses from the packaging and take off the camera lens cap from each camera. The lenses will need to be screwed onto the cameras until they are hand tight. Connect the HDMI and Power Cables to the Projector Locate the back of your projector and attach the HDMI and power cables.
- Page 8 Connect the USB 3.0 Cables to the Cameras Attach the USB 3.0 cables to the back of the cameras, and lock the cables with the locking screws. Connect USB 3.0 cables and HDMI cable to your computer. Plug the power cable into an electrical outlet.
- Page 9 The physical assembly of the HDI Carbon 3D Scanner is now complete! For next steps please see our online manual on the topic of setting up the HDI Advance 3D Scanner...
Need help?
Do you have a question about the HDI Carbon and is the answer not in the manual?
Questions and answers