Table of Contents
Advertisement
11. Starting up the Primetab for the first time
Charging the Primetab
Please fully charge your Primetab before you use it for the first time.
Connect the DC plug of the included power supply to the socket (DC IN) of the
Primetab. Then plug the power supply into an electrical outlet.
The charging LED lights up during charging. When the battery is fully charged,
the charging LED goes out.
ADVICE
i
Only leave the power adapter connected to the power socket until the Primetab is
fully charged. Disconnect the power adapter from the socket first and then remove
the charging cable from your Primetab.
i
ADVICE
The maximum battery life is reached after approximately charging cycles.
i
ADVICE
We recommend charging the Primetab while it is switched off. This allows you
to get the maximum charging speed.
Switching on the Primetab
Press the On/off switch for about 3 seconds to switch on the Primetab. The
status LED On/Off briefly lights up and the Primetab boots up. A configuration
assistant appears directly after the tablet has booted up. Follow the
configuration assistant instructions to set up your Primetab.
i
ADVICE
During the setup process, the configuration assistant will prompt you to sign in
with your Microsoft account. If you do not yet have a Microsoft account, please
set one up at this point.
Unlocking the display
As soon as the device has been set up (and every time it is subsequently
switched on and booted up), the lock screen appears. Press any key on the
keyboard to unlock the screen.
i
ADVICE
If your Primetab is password-protected, you must then enter the password.
19
Advertisement
Table of Contents
