DW DWC-V7253TIR Quick Start Manual

Quick Start Guide
DW® Universal HD over Coax®
ultra low-profile vandal dome cameras
DWC-V7253TIR
WHAT'S IN THE BOX
Mounting bolt Mounting
1 Set
and nuts templates
Mount Bolt & Nut
Mount Bolt & Nut Torx Wrench
Plastic Anchor-2pcs
Hex Allen Quick set up
1
wrench guide
Mount Bolt & Nut Torx Wrench
Screw &
Mount Bolt & Nut Torx Wrench
Plastic Anchor-2pcs
Template Sheet
Screws
for installing by Bolt & Nut
Test video
and plastic 1 Set
Template Sheet cable
anchors-2pcs
Manual
for installing by Bolt & Nut
Screw &
Template Sheet
Torx Wrench
Plastic Anchor-2pcs
Manual
for installing by Bolt & Nut
Template Sheet
NOTE: Download all your support materials and tools in one place.
Manual Test Video Cable
for installing by Bolt & Nut
1. Go to: http://www.digital-watchdog.com/resources
2. Search your product by entering the part number in
the 'Search by Product' search bar. Results for
applicable part numbers will populate automatically
based on the part number you enter.
3. Click 'Search'. All supported materials, including manuals
Manual Test Video Cable
and quick start guide (QSGs) will appear in the results.
Attention: This document is intended to serve as a quick reference for initial
set up. It is recommended that the user read the entire instruction manual for
complete and proper installation and usage.
Tel: +1 (866) 446-3595 / (813) 888-9555
Technical Support Hours:
9:00AM – 8:00PM EST, Monday thru Friday
STEP 1 – PREPARING TO MOUNT THE CAMERA
1. The mounting surface must withstand five times the weight of your
camera.
2. Pay attention to the cables. The can easily become caught and
damaged. Any damage may cause a short or fire.
3. Detach the camera's dome cover by loosening the three (3) screws on
the dome using the included torque wrench.
4. Use the mounting template to mark and drill the necessary holes in
the mounting surface.
Screw &
Mount Bolt & Nut Torx Wrench
Plastic Anchor-2pcs
1
Screw &
Torx Wrench
Plastic Anchor-2pcs
Screw &
Template Sheet
Manual Test Video Cable
for installing by Bolt & Nut
Screw &
1
Plastic Anchor-2pcs
Manual Test Video Cable
1
Test Video Cable
Test Video Cable
digital-watchdog.com
Protective sheet
Quick Start Guide
STEP 2 – CABLING THE CAMERA TO
EXTERNAL DEVICES
Pass the wires through the mount bracket and make all necessary
connections. Connect the BNC cable and power cables to the
camera.
Power requirements Power consumption
12VDC ONLY!
DC12V (LED off): 1.92W
CAUTION! The camera supports
DC12V (LED on): 3.12W
DC power supply only
Mounting template
Protective sheet