Operating Your Bath With Airjets - Kallista P50045-G5 Homeowner's Manual

Bath with airjets

Hide thumbs

Table Of Contents

Table of Contents

HOMEOWNERS GUIDE

USER KEYPAD AND BATH WITH AIRJETS MODES/FEATURES (CONT'D.)

 User Keypad "Sleep" Modes - To enhance your bathing experience, the keypad is programmed to

darken after approximately 15 seconds of inactivity. Only the last feature selected will remain illuminated.

To resume normal operation, press any key or turn the outer ring. Approximately 60 seconds after all

equipment is turned off, the keypad will darken completely to conserve power. Press the power button or

turn the outer ring to reactivate the keypad.

Air Flow Mode

Activates Mode Selected

Power On/Off

Rotate outer ring to

access desired mode.

Starting the Unit

If the unit does not function properly, please refer to the "Troubleshooting" section.

 Close the drain.

 Fill the bath to a level at least 2" (51 mm) above the top of the airjets.

 Use your hand to test the water temperature for comfort and safety.

 Carefully enter the bath basin.

 Press the On/Off button on the user keypad.

 Observe that the air system starts and air begins to ﬂ ow to all zones.

 If desired, adjust the air ﬂ ow rate using the up button or the down button.

 After about 15 seconds, observe that only the last feature selected remains illuminated on the user keypad.

Selecting Air Flow Modes

 Rotate the outer ring to select a desired mode.

 Observe that the selected icon is ﬂ ashing blue.

 Press the "OK" button to activate the mode.

 Observe that the active mode ﬂ ashes green and the mode is implemented.

 Observe that, after about 15 seconds, the icon stops ﬂ ashing.

1096755-5-D

6 of 16