Care And Cleaning Instructions - Kallista P50045-G5 Homeowner's Manual

Bath with airjets

Hide thumbs

Table Of Contents

Table of Contents

HOMEOWNERS GUIDE

 To turn off a mode, rotate the outer ring until the icon ﬂ ashes green and then press the "OK" button again.

 The icon will then turn blue indicating the mode is off.

Stopping the Bath

 When ready, press the power button a second time to stop the air system.

 Carefully exit the bath.

 Open the drain to empty the bath.

 Observe that, when the bath drains below the level sensors, the automatic 2-minute purge cycle occurs.

The air system operates at a low speed to blow any residual water out of the air channels.

 Observe that, about 60 seconds after shutdown, all user keypad lights extinguish.

Initiating a Manual Purge Cycle

 After stopping the air system and draining the bath, rotate the ring on the user keypad to the purge icon.

 Observe that the purge cycle icon is ﬂ ashing blue.

 Press the "OK" button once.

 The purge icon ﬂ ashes green and the mode is implemented. The air system operates at a low speed to

blow any residual water out of the air channels.

 After about 2 minutes, the air system stops automatically.

 Do not use powdered cleaners unless the cleaner is fully dissolved in water. Solid substances could block

the airjets.

 Do not use full strength bleach or ammonia cleaning solutions. Chemically active cleaning solutions can

damage the bath surface.

 Do not use abrasive cleansers or solvents on acrylic surfaces. Abrasive cleaners and solvents can damage

the bath surface.

 Wipe out your acrylic bath with a soft cloth after each use.

 Avoid detergents, disinfectants, or cleaning products in aerosol cans.

NOTE: To restore dull or scratched units: Apply white automotive polishing compound with a clean rag. Rub

scratches and dull areas vigorously. Wipe off residue. Follow with a coat of white automotive paste wax. Do not

wax areas where you walk or stand.

Cleaning Your User Keypad and Remote Control

 Use a soft cloth to wipe the keypad and remote control after each use. If the surface becomes dirty, use a

non-abrasive soap and warm water to clean.

1096755-5-D

7 of 16

OPERATING YOUR BATH WITH AIRJETS (CONT'D.)