Table of Contents
Advertisement
Malfunction
Temperature is not properly
adjusted.
Door was open for an exten-
ded period.
A large quantity of warm
The food is too warm.
food was placed in the
appliance within the last 24
hours.
The appliance is near a heat
source.
Interior lighting does not
Light bulb is defective.
work.
Door seal is not air tight (pos-
Heavy build up of frost, possi-
sibly after changing over the
bly also on the door seal.
hinges).
Appliance is not level.
The appliance is touching the
wall or other objects.
Unusual noises.
A component, e.g. a pipe, on
the rear of the appliance is
touching another part of the
appliance or the wall.
The compressor does not start
This is normal, no error has
immediately after changing
occurred.
the temperature setting.
Water on the floor or on sto-
Water drain hole is blocked.
rage shelves.
30
All manuals and user guides at all-guides.com
Possible Cause
Remedy
Please look in the "Initial Start
Up" section.
Open the door only as long as
necessary.
Turn the temperature regula-
tor to a colder setting tempo-
rarily.
Please look in the "Installation
location" section.
Please look in the "Changing
the Light Bulb" section.
Carefully warm the leaking
sections of the door seal with
a hair dryer (not hotter than
approx. 50 °C). At the same
time shape the warmed door
seal by hand such that it sits
correctly.
Readjust the feet.
Move the appliance slightly.
If necessary, carefully bend
the component out of the
way.
The compressor starts after a
period of time.
See the "Cleaning and Care"
section.
Rehingeing the door
The appliance's door has been locked in position for transport by means of
pins on both sides.According to the door opening direction, remove relevant
pins at the top and at the bottom.
Warning! When changing the side at which the door opens, the
appliance may not be connected to the mains. Remove plug from the
mains beforehand.
Housing dimensions
Height
1780mm
Depth
550 mm
Width
560 mm
Electrical connection
Before initial start-up, refer to the appliance rating plate to ascertain if sup-
ply voltage and current values correspond with those of the mains at the
installation location.
e.g.:
AC
220 ... 240 V
220 ... 240 V~
50 Hz
(i.e. 220 to 240 volts alternating current, 50 Hertz)
The rating plate is inside the appliance on the left.
A correctly installed, earthed socket is required for the electrical supply. The
supply must have a fuse rating of at least 10 Amps.
If the socket is not accessible once the appliance is built in, the electrical
installation must include suitable means of isolating the appliance from the
mains (e.g. fuse, cut-out, current trip or similar with a minimum contact
separation of 3 mm).
Attention: The mains connection cable may only be replaced by a skilled
electrician. Please contact your dealer or our customer service department
for repairs.
Prior to Initial Start–Up
• Please clean the appliance interior and all accessories prior to initial start-
up (see section: "Cleaning and Care").
50 Hz or
23
Advertisement
Table of Contents
