Dometic CFX Series Operating Manual page 21

CFX75DZW, CFX95DZW
The display brightness can be dimmed for low ambient light conditions. To set the
dimming level of the display proceed as follows:
➤ Switch on the cooler.
➤ Press the "SET" button (fig. 3 4, page 2) five times.
➤ Use the "UP +" (fig. 3 7, page 2) or "DOWN –" (fig. 3 6, page 2) buttons to
set the brightness of the displays.
✓ Display will be as follows:
d0 (default), d1 (medium), d2 (dark)
✓ The displays show the set mode for some seconds. The displays flash several
times before they returns to the current brightness.
I
The factory setting of brightness of the display is d0 (default).
If a fault occurs, the brightness automatically is d0 (default). After
troubleshooting the set brightness is reactivated.
The emergency switch (fig. 4 3, page 3) is located below the control panel. For
normal operation the switch is in the "NORMAL USE" position.
➤ If an electronic control failure occurs, slide the switch to "EMERGENCY
OVERRIDE" position.
I
If the switch is in the "EMERGENCY OVERRIDE" position, the cooler
circuit runs with full cooling capacity and, depending on the running
conditions of each compartment at the time of switching, may either
freeze one or both compartments, and/or stop cooling one of the
compartments.
Operation
21