Moen 5900 Series Installation Instructions

5900 SERIES
WIDESPREAD LAVATORY MODELS
1-1/2"
2-3/4"
ESCUTCHEON
2-5/8"
1-7/8" DIAMETER
WASHER
MOUNTING
NUT
TAILPIECE
NUT
CAUTION:
Before turning water on during either rough-in or trim-out, make sure the cartridge retainer nuts are in place. The cartridges and
cartridge retainer nuts were properly installed and tested before leaving the factory. Although it is unlikely, it is nevertheless pos-
sible that through the handling of the faucet by any number of persons the cartridge retainer nuts may not be properly installed.
This should be carefully checked at time of rough-in and trim-out. If the cartridge retainer nuts are not properly installed, water
pressure could force the cartridge out of the faucet body. Personal injury or water damage to the premises could result.
®
LEVER & CROSS HANDLE
HANDLE INSERTS
NOT INCLUDED
FLOW-RATOR
AERATOR
HOT
SPOUT UNION TEE
8-16" CENTERS
Always turn water OFF before disassembling the faucet. Open faucet handles to relieve water
pressure and to insure that COMPLETE water shut-off has been accomplished.
INSTALLATION INSTRUCTIONS
2-3/4"
1-1/4" MAXIMUM
DECK THICKNESS
COLD
WATER SUPPLIES
(NOT FURNISHED)
THESE INSTRUCTIONS MUST BE
LEFT WITH HOMEOWNER
1-5/8"
5-1/8"
SPOUT INSTALLS THROUGH 1" MIN. DIAMETER HOLE.
VALVE INSTALLS THROUGH 1-1/8" MIN. DIAMETER HOLE.
MT128B