Black & Decker CS1000L Instruction Manual page 10

631798-01, CS1000L Cir Saw
TO USE LASER LINE ON SAW
• Mark the line that you intend to cut on
the workpiece.
• Adjust the depth and angle of cut as
required.
• Switch the laser to the "ON" position
and project the laser beam as shown in
figure 14.
14
• Plug in the saw and squeeze the
trigger.
• Allow the blade to reach maximum
speed and place the saw on the
workpiece. Align the laser line with the
mark on the workpiece and slowly push
the saw forward keeping the laser line
on the mark.
• Upon completion of the cut, release the
trigger and allow the saw blade to
come to a complete stop before
switching off the laser.
TO USE LASER OFF SAW
The laser can be removed from the saw
and used for a variety of different
applications.
To use the laser off the saw, fold down
the front leg as shown in figure 15.
15
17
12/16/05 1:14 PM Page 10
The laser can also be used in conjunction
with the protractor in three different ways:
(1) 360 degrees - To project the laser line
any direction in a complete circle, 1st
retract the front leg and then insert the
two back legs into the groove of the
protractor as shown in figure 16.
16
(2) Fixed Position - To use the laser in
the fixed position, place the rear legs in
the holes on the protractor. Refer to
figure 17 for the angles created when
using the laser in these holes.
(3) Protractor on Edge of Workpiece -
To use the laser on the edge of your
workpiece, rotate the legs of the
protractor so that they are straight up and
down as shown in figure18. Place the
protractor against the edge of the
workpiece and center the large hole of
the protractor over the intended line of
cut.
18
BB
AA
EE DD
CC CC
DD EE
AA
BB
10
to AA = 0° Right
AA
to BB = 0° Left
BB
CC to CC = 90°
DD to DD = 45° Left
EE to EE = 45° Right