Dell Poweredge 1750 Quick Start Manual page 2

Installing a romb card (perc4/di)

Hide thumbs Also See for Poweredge 1750:

Figure 6-11. Installing the ROMB Card and Backup Battery

7. Install the ROMB backup battery:

a. Position the battery board as shown in

two standoffs until it snaps into place.

b. Plug the battery cable into the RAID BATTERY connector on the system board.

8. If you removed a PCI card in

9. Close the system covers. See

System."

10. Reconnect the system and peripherals to their power sources, and turn them on.

11. Enter the System Setup program and verify that the setting for the SCSI controller has

changed to reflect the presence of the RAID hardware. See "Using the System Setup

Program" in your User's Guide.

12. Install the RAID software. See the ROMB card software documentation for more

information.

Figure

step

4, replace it. See

"Closing the System

6-11, and press it down into the

"Installing an Expansion

Covers" in "Troubleshooting Your

Card."