Advertisement
2.1 Loose the wire-tightening screws of the wire
holder with the slotted screwdriver for
certain space in order to insert the electrical
wires into the connecting holes. Tighten the
screws with the screwdriver till the wires are
well fixed.
2.2 After connecting the wires, securely screw
the threaded clamp to fix the position of the
wires.
3. Arrange the wires neatly and then fix the
backplate of the fixture on the tightened
mounting plate with screws.
4. Insert the bulb of E14 spec which can be
contained in the glass diffuser into the socket
cup. (Please note that the power rating of the
bulb should within the limit of power rating
which listed on the label.)
5. Carefully set the glass diffuser into rubber
cup in the socket cup, and make sure that it
is fixed on the socket cup securely.
6. After the installation and checking, power on
and a scone is ready to be used.
Note: Please use glass sealant to fill the
clearance between the upper part of
the backplate and the finished wall if
the installation place is suspected to
have water sprayed in. That is to
prevent the water from entering into
the backplate and cause any possible
accident.
1115671-T01-A
2.1
2.2
3.
4.
E14
5.
6.
-3-
Advertisement
