Advertisement
INSTALLATION
If you are not sure how to install this unit correctly, consult your JVC car audio dealer.
In dash-mounting
Do the required electrical
connections.
Bend the appropriate tabs
to hold the sleeve firmly
in place.
When using the optional stay
Stay (option)
Fire wall
Dashboard
Screw (option)
ELECTRICAL CONNECTIONS
Make sure to disconnect the battery's negative terminal.
• Be sure to ground this unit to the car's chassis again after installation.
Note:
It is recommended to connect to the speakers with maximum power of more than 45 W (both at the rear and at the front,
with an impedance of 4 Ω to 8 Ω). If the maximum power is less than 45 W, change "AMP GAIN" setting to prevent the
speakers from being damaged (see "General settings—PSM").
Typical connections
Rear ground terminal
Line out
Antenna
terminal
Black
Connect only the front speakers if your
speaker system is two-speaker system.
White with black stripe
Yellow *
Front speaker (left)
White
Gray with black stripe
Red
Front speaker (right)
Gray
Blue with white
Green with black stripe
stripe
Rear speaker (left)
Green
Purple with black stripe
Rear speaker (right)
Purple
PRECAUTIONS on power supply and speaker connections
When you stand the unit, be careful
not to damage the fuse on the rear.
In a Toyota car for example, first remove the car radio and install the unit in its place.
Install the unit at an angle of
less than 30˚.
15 A fuse
Ignition switch
To metallic body or
chassis of the car
To a live terminal in the
fuse block connecting to the
2
car battery (bypassing the
ignition switch) (constant
12 V)
Fuse block
To an accessory terminal in
the fuse block
To the remote lead of other
equipment or automatic antenna if
any (200 mA max.)
Before removing the unit, release the rear section.
When installing the unit without using the sleeve
Flat type screws
—M5 × 8 mm (M5 × 3/8")*
Bracket*
Flat type screws
—M5 × 8 mm (M5 × 3/8")*
Pocket
Bracket*
High
Connecting the external amplifier or subwoofer
Set "L/O MODE" to "REAR"
(See "General settings—PSM.")
You can connect a power amplifier for rear
speakers.
JVC Amplifier
Rear speakers
Set "L/O MODE" to "WOOFER"
(See "General settings—PSM.")
You can also connect a subwoofer to the REAR
LINE OUT terminals.
JVC Amplifier
Subwoofer
*
1
Not supplied for this unit.
*
2
Before checking the operation of this unit prior to installation, this lead must be connected, otherwise power cannot be
turned on.
*
3
Firmly attach the ground wire to the metallic body or to the chassis of the car—to the place uncoated with paint (if
coated with paint, remove the paint before attaching the wire). Failure to do so may cause damage to the unit.
*
4
Signal cord (not supplied for this unit)
4 – EN
Removing the unit
* Not supplied for this unit.
Heat sink
Remote lead
Y-connector *
Remote lead (blue with white stripe)
To the remote lead of other equipment
or automatic antenna if any
1
Front speakers
Advertisement
