INSTALLATION INSTRUCTIONS FOR INSTALLING DRIFTWOOD AND CHARRED OAK* LOG SETS FOR USE WITH
SCORPIO AND DRT3500 SERIES DIRECT-VENT GAS FIREPLACES
KIT CONTENTS
1 ea. Log Set
1 ea. Instruction Sheet
TOOLS NEEDED
None
Log Sets - Traditional Models *
Cat. No.
Model
F2876
CHAROAK35
F2877
CHAROAK40-45
F2878
DFTWOOD35
f i r e - p a r t s . c o m
F2879
DFTWOOD40-45
Table 1
* DRT3500 Series fi replaces are approved for use with the Charred Oak Log Sets only.
GENERAL INFORMATION
This log placement guide has been prepared to present detailed log
placement illustrations and provide instruction to assist in the placement
of logs at the initial (new appliance) setup and after the annual cleaning
and inspection cycles. The information provided here is to be used in
conjunction with the Installation and Operation Instructions provided
with the appliance.
If you encounter any problems, need clarifi cation of these instructions or
are not qualifi ed to properly install this kit, contact your local distributor
or dealer.
Read this instruction sheet in its entirety before beginning the installation.
DO NOT attempt to install the logs until the appliance installation has
been completed, the gas line connected and tested for leaks and the
initial burner operation has been checked out.
The logs have notches/tabs to assist proper positioning. Upper logs rest
on lower logs via notches/tabs. Proper log placement is critical to prevent
sooting. Place the logs in the gaps between fl ame peaks, so they do not
impinge the fl ames. Follow the log placement instructions precisely.
ALL WARNINGS AND PRECAUTIONS IN THE INSTALLATION AND
OPERATION MANUAL PROVIDED WITH THE APPLIANCE APPLY TO
THESE INSTRUCTIONS.
SHUT DOWN THE APPLIANCE AND ALLOW IT TO COMPLETELY COOL
BEFORE PROCEEDING.
Description
35" Charred Oak Log Set
40" and 45" Charred Oak Log Set
35" Driftwood Log Set
40" and 45" Driftwood Log Set
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
P/N 900796-00
CHARRED OAK AND DRIFTWOOD LOG SETS
Rev. NC, 09/2016
INSTALLATION INSTRUCTIONS - 35/40/45 DRIFTWOOD LOG SET
(Scorpio series only)
3
6
Log Number
1
2
3
4
5
6
Figure 1
1.
If necessary, remove the glass door per instructions in the
Installation and Operation Manual. Locate the placement tabs
(Figure 2).
2.
Bend up the log placement tabs (Figure 2). Place glowing embers
and other media (see Figure 2).
Tab for
Log #1
Tab for
Log #2
Place Glowing Embers
Figure 2 - Locate the log placement tabs
HEARTH PRODUCTS
KITS AND ACCESSORIES
2
5
1
Description
Left Rear Log
Rear Log
Left Top Log
Right Bottom Log
Right Top Log
Front Ember Log
Log Location Tabs
Tab for
Log #2
4
1