Denon DVD-2500BT Quick Start Manual page 3

Hide thumbs Also See for DVD-2500BT:

Erstelldatum 29.08.2008 14:45:00

During the update process it is imperative

that you do not switch off the unit's power

15.

and/or press any of the buttons on the unit or

remote control unless otherwise instructed.

After programming* is finished, the checksum

16.

is indicated on the unit's display

Once the checksum has been shown the

17.

update procedure is completed.

Unplug the AC cord from the AC outlet.

18.

Then plug it again.

Turn the power on by pressing the

19.

[POWER ON] button.

In order to verify new firmware version please

20.

repeat Steps 4, 18 and 19.

Notes:

Your player's settings will have been returned to their factory defaults.

Please re-configure the player (according User manual ) to your requirements. Denon do not advise the

loading of any non-official firmware into your DVD player. Doing so could compromise the features and

performance of your player.

579 Bath Road, Longford, Middlesex, UB7 0EW.

Seite 3 von 3

[57E9]

* At this time, no button is available.