Table of Contents
Advertisement
Precautions
This document provides guidelines for quick hardware installation.
This document does not describe assembly of equipment prior to delivery; it only describes procedures
for onsite installation.
CAUTION
Power Supply
The equipment uses a -48 V/-60 V DC power supply. An AC power supply or a high-voltage power
supply may cause equipment damage or even human injuries and therefore is forbidden.
Electrostatic Discharge
To prevent damage to sensitive components caused by electrostatic discharge, wear ESD gloves or an
ESD wrist strap when handling the equipment, boards, or IC chips. Ensure that the ESD wrist strap is
properly grounded.
OptiX RTN 905
Binding Cables
Bind fibers or cables inside a cabinet at intervals of not more than 250 mm and user cables at intervals of
not more than 200 mm.
Bind fibers, cables, or corrugated pipes outside a cabinet at intervals equal to the distance between two
horizontal beams. If the cable trough does not have any beams, the intervals should not exceed 250 mm.
Pre-installation Check
Before beginning the installation, check the equipment room, cabinet, power supply, ground cables,
fibers, and associated facilities to confirm that all preparations are complete .
2
ESD
Hide quick links:
Advertisement
Table of Contents
