Melitta Cafe Cappuccino MEX6B User Manual page 7

7. Place the Filter Basket into the Filter Holder
(see FIGURE 3). Make sure that the Filter
Basket Clip is open and resting back along
the Filter Holder handle.
8. Position the Filter Holder beneath the water
outlet so that the handle is aligned with the
" " (UNLOCK) symbol. Lift the Filter Holder upwards so that it
evenly fits into the water outlet; then slide the handle to the right until
it is positioned securely beneath the "
9. Place the Carafe Lid onto the Carafe; then slide the Carafe onto the
Drip Tray so that the fill-hole in the Carafe Lid is positioned directly
beneath the Filter Holder spout.
10. Plug the Espresso Maker into a 120V AC electrical outlet and flip the
Power Switch to the "I" (ON) position. The Power Switch will illumi-
nate indicating that the unit is on.
11. To begin brewing, slide the Function Control to the desired "
(BREW) setting -- adjust along the Brew Strength Scale according to
taste. As the water begins to heat, espresso will start to flow through
the Filter Holder spout.
NOTE: Pressure building inside the machine may be heard during
the brewing process. This is not uncommon.
WARNING: DO NOT open the Boiler Cap or remove the Filter
Holder during the brewing process -- scalding may occur.
WARNING: Never operate the Espresso Maker without water in
the Water Tank.
If making cappuccino/latte/coffee drinks requiring the use
of the Frother, skip ahead to the "Frothing Milk" section
12. WATCH AS THE CARAFE IS BEING FILLED. Once the level of
espresso reaches the desired cup marking on the Carafe, slide the
Function Control to the " " (STEAM) position.
WARNING: The Espresso Maker WILL NOT shut off automati-
cally. DO NOT leave the unit unattended during use to prevent
overflowing.
and proceed as instructed...
6
" (LOCK) symbol.
"