Securing Child In Child Restraint - DJG Alpha Omega 65 Manual

8. To Adjust Harness/Headrest
Height
Make sure the harness straps
are loose. Pull the metal headrest
adjustment bar on the back of
the seat. Move metal headrest
adjustment bar up or down to the proper height. Release metal
headrest adjustment bar into slot to lock. Make sure metal
headrest adjustment bar is securely locked into place.
Make sure
is locked
Failure to do this can
result in serious injury
or death.
Do not use this child restraint
rear-facing if the top of your
child's head is above the top of
the child restraint's headrest.
Do not use this child restraint
forward-facing if the midpoint of
your child's ears are above the top
of the child restraint's headrest.
Make sure the harness height is correct for
your child's size.
Incorrect use of the harness system is the
most common mistake people make. Verify
frequently that the harness height is correct
for your child's size. It is very important to
read, understand and follow all instructions
and warnings.
Failure to follow these steps can result in
serious injury or death.
15
4358-5978 Alpha Omega ENG.indd 17-18 4358-5978 Alpha Omega ENG.indd 17-18
C-3 Securing Child in Child Restraint
metal bar
into position.
1. Position Harness
Straps Over the
Child's Shoulders
Place the child's bottom
and back flat against the
child restraint. This will
increase comfort and allow
the harness straps to be
properly tightened.
2. Buckle Harness
Push each buckle tongue
into buckle until you hear
a "click." Remember to
always pull up on harness
straps to make sure buckle
is locked.
3. Close Chest Clip
Insert right half of chest
clip into left half and snap
together.
continued on next page.
16
11/9/12 3:44 PM 11/9/12 3:44 PM