Advertisement
Malem Wireless Alarm Enuresis Alarm
Instructions:
1.
Place the Bed-Mat over the mattress in the area which is normally
wetted and gently tie down.
2.
Cover the bed-mat with a Clean Dry Cotton sheet and/or Bath
Towel and make the bed up as usual.
3.
Attach the Bed-Mat wire to the Tx Transmitter and place the alarm
beside the bed.
4.
Please tuck in the Bed-Mat wire so that it is not in the way for
getting in and out of bed.
5.
The Receiver sound can be stopped ONLY when the Bed-Mat wire
is unlocked from the Tx or the Rx reset button is pressed. Rx will
alarm again in 3 minutes if Tx is detecting wettness.
6.
The Bed-Mat must be wiped clean with detergent and dried then
replaced in a freshly made bed, as before, for reuse.
7.
Adjust the loudness of the sound with the volume control.
Hints
The rest button will stop the Rx from sounding only for 3 minutes if the Bed-
Mat is not disconnected from the Tx.
The Bed-Mat positively locks to the Tx to prevent accidental disconnection.
However, it must be unlocked before attempting to reset the alarm on the Rx.
Please use a thicker cotton sheet or place a bath towel above the Bed-Mat if
sweating is triggering the alarm prematurely. Avoid plastic and Man-Made
fibers as they may cause static discharge and false alarm.
Treat the Bed-Mat with care. Avoid folding it or jumping over it.
Please replace the Bed-Mat with a new one if it has deteriorated and use a
new one with each child.
Please note that sleeping directly over an uncovered Bed-Mat or touching it
by hand may trigger the alarm.
Bed-Mat Sensor
4
Advertisement
