Advertisement
Operating Instructions: "Please READ"
1. Make sure the encode switch is set to the same position in
both the Transmitter (Tx), and Receiver (Rx) "Matching pair".
Do NOT mix with others of different Code setting as the "pair"
will not communicate with each other if NOT code matching.
2. Make sure fresh Alkaline batteries are in both Tx (2 X AAA) &
Rx (4 X AA).
3. Remove isolating tags from battery compartments of both Tx
(remove first) and Rx if new from Malem Medical. Rx will beep
until signal is received from Tx. Allow up to 13 seconds.
(Battery saving feature).
4. Red LED must flash on Tx and Green LED must flash on Rx,
(once every 5 seconds). Make sure batteries are new and
making good contact inside compartment if LEDs do not
flash. Record user's name or
personal message or music if
you wish or select type of alarm.
See diagram.
5. Plug in Easy-Clip© Sensor (make
sure leaver is lifted open),
Standard Sensor or Bed-Mat (both
optional extra) to Tx. The
Easy-Clip© Sensor can be
attached to the outside of close
fitting pants. The Standard
Sensors can be placed inside a
sanitary pad or nappy and for the
Bed-Mat, between the sheets under
the user so that the Tx is
triggered as soon as it detects
urination or wetness. (See page 4 for
Bed-Mat instructions)
Secure the Easy-Clip
onto the material by
pressing down the lever
Place material
into mouth of
the Easy-Clip
2
Advertisement
