Pedicraft Canopy Enclosed Bed Operation Manual page 6

6 of 18
Figure 1
Assembly of the bed is easier with two
people.
Place one End Frame on its side. The padded
Cross Bar identifies the top of the frame.
Position the Mattress Deck on its side just
below the padding on the End Frame
Figure 2
Place the brackets of the Mattress Deck
through the End Frame one at a time past
the point where the holes line up.
Bring the bottom bracket back through the
End Frame and align the holes in the bracket
with the holes in the End Frame.
Figure 3
Pull the square tube of the End Frame over
the Mattress Deck bracket and align the
holes. The fit will be very snug.
Insert four 2" bolts and washers from the
outside of the frame and attach nuts. Do not
fully tighten.
Attach the second End Frame.
Figure 4
Attach padded Support Bars to the top of
the bed frame with 2" bolts. Do not fully
tighten.
If bed is a height adjustable model, continue
to next figure. If not, skip to figure 11.
Pedicraft Inc. 4134 St. Augustine Rd. Jacksonville, FL 32207 Ph: 904-396-9627
Rev. 9 - 091919