Flex CHE 18.0-EC Manual page 18

430.013_CHE 18.0-EC.book Seite 19 Mittwoch, 30. September 2015 1:12 13
CHE 18.0 - EC
NOTE!
The rotary knob must audibly click into
–
place in all positions.
Do not switch on the power tool in the
–
position (setting the chisel position).
Setting the chisel position
The chisel can be turned to a position which
is ideal for the work to be performed.
 Move the operating mode rotary knob to
the symbol (1.).
 Turn the chisel until it is at the required
angle (2.).
 Move the operating mode rotary knob to
the symbol (3.). Make sure it audibly
clicks into place.
Switching on the power tool
 Press and hold down the trigger switch.
The power tool trigger switch enables
the speed or impact rate to be increased
slowly to the maximum value.
The LED illuminates the working area when
the power tool is switched on.
To switch off the machine:
 Release the trigger switch.
Operating instructions
Drilling/hammer drilling
1. Move the operating mode rotary knob to
the (drilling) or (hammer drilling)
symbol. Make sure it audibly clicks into
place.
2. Insert the drill bit.
3. Swivel the auxiliary handle into
the required position.
4. Insert the battery.
5. Grip the power tool with both hands and
assume the working position.
6. Position the drill bit and switch on the
power tool.
7. Gently press the power tool forwards.
8. After drilling, switch off the power tool.
Chiselling
1. Insert the chisel.
2. Move the operating mode rotary knob to
the symbol.
3. Turn the chisel into the required
position.
4. Move the operating mode rotary knob to
the symbol. Make sure it audibly clicks
into place.
5. Swivel the auxiliary handle into
the required position.
6. Insert the battery.
7. Grip the power tool with both hands and
assume the working position.
8. Switch on the power tool.
9. When chiselling, gently press the power
tool forwards to prevent it from jumping.
10. After working, switch off the power tool.
Other information
– The use of "sharp" cutting accessories
increases performance and the service
life of the power tool.
– After work, clean the power tool and store
in the carrying case in a dry location.
19