Blodgett McDonald's KCO-25E Installation Operation & Maintenance
Hide thumbs
Also See for McDonald's KCO-25E:
- Installation, operation and maintenance manual (19 pages) ,
- Installation and operation manual (205 pages)
Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Blodgett McDonald's KCO-25E
Summary of Contents for Blodgett McDonald's KCO-25E
- Page 1 KCO-25E CONVECTION OVEN INSTALLATION -- OPERATION -- MAINTENANCE BLODGETT OVEN COMPANY www.blodgett.com 44 Lakeside Avenue, Burlington, Vermont 05401 USA Telephone (800) 331-5842, (802) 860-3700 Fax: (802)864-0183 PN 31594 Rev C (6/01) E 2000 --- G.S. Blodgett Corporation...
- Page 2 IMPORTANT WARNING: IMPROPER INSTALLATION, ADJUSTMENT, ALTERATION, SERVICE OR MAINTENANCE CAN CAUSE PROPERTY DAMAGE, INJURY OR DEATH. READ THE IN- STALLATION, OPERATING AND MAINTENANCE IN- STRUCTIONS THOROUGHLY BEFORE INSTALLING OR SERVICING THIS EQUIPMENT FOR YOUR SAFETY Do not store or use gasoline or other flammable vapors or liquids in the vicinity of this or any other appliance.
- Page 3 THE REPUTATION YOU CAN COUNT ON For over a century and a half, The Blodgett Oven Company has been building ovens and nothing but ovens. We’ve set the industry’s quality standard for all kinds of ovens for every foodservice operation regardless of size, application or budget.
- Page 4 Your Service Address: Model: Serial Number: Your oven was installed by: Your oven’s installation was checked by:...
-
Page 5: Table Of Contents
Table of Contents INTRODUCTION Electrical Specifications ..........Oven Approvals . -
Page 6: Introduction Electrical Specifications
INTRODUCTION ELECTRICAL SPECIFICATIONS KIOSK CONVECTION OVEN KCO-25E AMPERES ELECTRICAL CONNECTION CONNECTION KW/SECTION VOLTS (60 HZ) PHASE AWG* * Refer to Page 4 in this manual for Electrical Connection specifications Load ratings are double the above data for Double Stacked units. -
Page 7: Oven Approvals
INTRODUCTION OVEN APPROVALS KCO-25E KCO-25E Single Double Stacked... -
Page 8: Pre-Installation
INTRODUCTION PRE-INSTALLATION DELIVERY All Blodgett Ovens are strapped on heavy wooden skids, and surrounded by tri-wall cartons to prevent INSTALLATION INSTRUCTIONS shipping damage. When tendered to the carrier, CONTAINED HEREIN ARE FOR THE USE each unit has been carefully inspected and packaged. -
Page 9: Installation
INSTALLATION OVEN LOCATION The well planned and proper placement of the oven WARNING will result in long term operator convenience and sat- isfactory performance. It is therefore, urged that ad- THIS APPLIANCE IS EQUIPPED equate thought be given to the location of the oven WITH A THREE-PRONG GROUND- prior to its delivery for installation. -
Page 10: Oven Assembly
INSTALLATION OVEN ASSEMBLY MOUNTING OVEN ON 4” LEGS: NOTE: Before operating the KCO-25E, the unit must be mounted on the legs provided. 1. Tilt the oven onto its back. 2. Screw 4” legs into 4 holes located near oven cor- ners. - Page 11 INSTALLATION DOOR RELOCATION The KCO-25E is shipped with the door hinged on the 5. Relocate the handle and plate assembly on the right side. If left hand operation is necessary use the door as follows: following procedure to relocate the door. a.) Remove the four hex head screws which attach the handle plates to the door.
-
Page 12: Operation
OPERATION GENERAL GUIDELINES FOR OPERATING PERSONNEL THE INFORMATION CONTAINED IN TO OBTAIN OPTIMUM PERFORMANCE FROM THIS SECTION IS PROVIDED FOR THE THE KCO-25E, PLEASE OBSERVE THE FOL- USE OF QUALIFIED OPERATING PER- LOWING PROCEDURES AND SUGGESTIONS. SONNEL. QUALIFIED OPERATING PER- SONNEL ARE THOSE WHO HAVE CARE- Follow the Time and Temperature recommenda- FULLY READ THE INFORMATION CON-... -
Page 13: Oven Controls
OPERATION OVEN CONTROLS DISPLAY MESSAGES 1. POWER ON/OFF - Controls the operation of Indicates the oven is heating to, or cycling at the oven. If the power switch is lighted the power the idle temperature. (Temperature the to the unit is on. If the power switch is not lit, the oven maintains when not in use). -
Page 14: Oven Operation
OPERATION OVEN OPERATION When the display flashes unit is at the programmed temperature. NOTE: The display examples given below are for a 3. If the wrong product is selected repeat Step 2 us- single pan of product 1. ing the correct PRODUCT KEY (4). 1. -
Page 15: Product Programming
OPERATION PRODUCT PROGRAMMING 4. The control flashes then displays the cur- rent time for three pans of product. NOTE: The example given below is for Product 1. The new cook time for three pans of product may now be entered in minutes and seconds. Use To enter the Program Mode: product key 5 to increase the time. -
Page 16: Maintenance
MAINTENANCE CLEANING THE OVEN On the stainless exterior, deposits of baked on splat- ter may be removed with any of the following ele- ments: Grade FFF Italian Pumice, Liquid Nu Steel, Permapass, Samea or Cameo paste, Nu Steel, or Du- Bois Temp. -
Page 17: Troubleshooting Guide
* Denotes remedy is a difficult operation and should be performed by qualified personnel only. It is recommended, however, that All repairs and/or adjustments be done by your local Blodgett service agency and not by the owner/operator. Blodgett cannot assume responsibility for damage as a result of servicing done by unqualified personnel. - Page 18 CUSTOMER INSERT WIRING DIAGRAM HERE...
- Page 19 Blodgett Oven Company agrees to pay any authorized Blodgett service agency within the Continental United States for any labor required to repair or replace, at Blodgett Oven Company’s option, any part which proves to be defective due to defects in material or workmanship during the warranty period. This warranty includes travel time not to exceed two (2) hours and mileage not to exceed one hundred (100) miles, round trip.