Clean And Maintenance - Crown CEM-1515 Instruction Manual

Table of Contents

Advertisement

Note: Clean steam outlet with wet sponge immediately after steam stops generating, but care not to hurt!
6. Pour the frothed milk into the espresso prepared, now the cappuccino is ready. Sweeten to taste and if
desired, sprinkle the froth with a little cocoa powder.
7. Press and release the
source off.
Note: we recommend you allow the maker to cool down at least for 5 min before making coffee again.
Otherwise burnt odor may occurred in your Espresso coffee .
PRODUCING STEAM TO HEAT LIQUIDS
The steam wand (without the frothing device) can be used to make hot beverages like drinking chocolate,
water or tea.
Method:
1. Remove the detachable tank and fill it with desired water, the water level should not exceed the "MAX"
mark in the tank. Then place the tank into the appliance properly.
2. Then connecting the appliance to power supply source.
3. Press down the ON/OFF button to the lower position which is the "
(red) is illuminated.
Press down the pump control button to the lower position which is the "
4.
coffee/steam button is on the higher position which is the
there is water flowing out, close the pump immediately, pressing down the coffee/steam button to the
lower position which is the
until the green lamp is illuminated, it shows the heating is finish.
5. Remove the frothing device from the steam wand.
6. Dip the steam wand into the liquid to be heated. Turn the steam control knob in anti-clockwise slowly to
start making steam.
7. When the required temperature is reached, you can turn the steam control knob to the minimum
position.
8. Press and release the
source off.

CLEAN AND MAINTENANCE:

1、Cut off power source and let the coffee maker cool down completely before cleaning.
2、Clean housing of coffee maker with moisture-proof sponge often and clean water tank, drip tray and
removable shelf regularly then dry them.
Note: Do not clean with alcohol or solvent cleanser. Never immerse the housing in water for cleaning.
3、Detach the metal funnel through turn it clockwise, get rid of coffee residue inside, then you can clean it
with cleanser, but at last you must rinse with clear water.
to the higher position which is the "
ON/OFF button
position and waiting for a moment, the appliance begins to be heated
to the higher position which is the "
ON/OFF button
" position to cut the power
" position, the power indicator
" position, make sure the
position, the pump will pump water, when
" position to cut the power

Advertisement

Table of Contents
loading

Table of Contents