Automatic Power Off Function; Factory Reset; Cleaning And Maintenance; Cleaning Mineral Deposits - Crown CEM-1526 Instruction Manual

Table of Contents

: After finish the "Steam" function, press the coffee switch, if the coffee indicator and

WARNING

steam indicator blink fast, it means that the temperature of the appliance is too high and the appliance

needs to be turned off and have a rest for more than 5 minutes, or you can activate the "Hot water"

function to cool down the appliance. And the water pump will stop pumping water automatically if

the temperature is normal. And the coffee will be burnt and there will be overflow at the funnel if the

appliance brew coffee directly without being cooled down.

AUTOMATIC POWER OFF FUNCTION

If there is no any operation within 25 minutes, the unit will power off automatically.

After finish preheating, hold and press the power switch, coffee switch and steam switch for 3 seconds

at the same time, and their corresponding indicators will blink for 3 times, then the factory reset is

finished.

1、Cut off power source and let the coffee maker cool down completely before cleaning.

2、Clean housing of coffee maker with moisture-proof sponge often and clean water tank, drip tray

and removable shelf regularly then dry them.

Note: Do not clean with alcohol or solvent cleanser. Never immerse the housing in water for cleaning.

3、Detach the metal funnel by turning it clockwise, get rid of coffee residue inside, then you can

clean it with cleanser, but at last you must rinse with clear water.

4、Clean all the attachments in the water and dry thoroughly.

A descaling prompt will occur automatically after working for 500 cycles cumulatively, at that time, all

the indicators will quickly blink for 5 times at the same time after preheating is finished. And the

appliance will become normal again after the descaling is finished.

2.Fill the tank with water and descaler to the MAX level ( the scale of water and descaler is 4:1, the

detail refers to the instruction of descaler. Please use "household descaler", you can use the citric acid

(obtainable from chemist's or drug stores) instead of the descaler (the one hundred parts of water and

three parts of citric acid).

3.According to the program of pre-heating, put the metal funnel (no coffee powder in it) and jug in

place. Brewing water per " PRE-HEATING".

4. Press the

switch one time, its red lamp will be illuminated, you should press the pump control

Power

switch, maker sure the coffee/steam selector , when there is water flowing out and close the pump, and

wait for a moment, the coffee maker begins to be heated.

5. When the lamp in pump control switch is illuminated, it shows the heating is finished. Pressing the

Table of Contents