Crown CEM-1515 Instruction Manual page 5

2. Set steel mesh into metal funnel, make sure the tube on the funnel aligns with groove in the appliance,
then insert the funnel into the appliance as indicating of "Insert" mark, and you can fix them into
coffee maker firmly through turn it anticlockwise until it is at the lock position.(See fig. 1).
3. Pour out the hot water in the cup. Then place the hot cup (yourself cup) on removable cup shelf.
4. At the time, the ready indicator (green) is illuminated, once the green lamp is illuminated, you should
press down the pump control button to the lower position which is the "
there will be coffee flowing out.
Note: During continuous operations, the ready indicator is likely to extinguish due to the inadequate
temperature of the water in the boiler, but it does not mean the unit will stop operating, you may continue to
make coffee regardless of it.
5.You should press and release the
when desired coffee is obtained or the colour of coffee changes weak obviously, the power indicator and
ready indicator go out and the coffee maker stops working, your coffee is ready now.
WARNING: Do not leave the coffee maker unattended during making the coffee, as you need operate
manually sometimes!
6. After finishing making the coffee, you can take the metal funnel out through turn clockwise, then pour the
coffee residue out with the steel mesh pressed by press bar.
7. Let them cool down completely, then rinse under running water.
FROTHING MILK/ MAKE CAPPUCCINO
You get a cup of cappuccino when you top up a cup of espresso with frothing milk.
Method:
1、Prepare espresso first with container big enough according to the part "MAKE ESPRESSO COFFEE",
make sure that the steam control knob is at the minimum position.
2、Press down the coffee/steam button to the lower position which is the
the ready indicator (green) is illuminated.
Note: During continuous operations, the ready indicator is likely to extinguish due to the inadequate
temperature of the water in the boiler, but it does not mean the unit will stop operating, you may continue
to make coffee regardless of it.
、
3 Fill a jug with about 100 grams of milk for each cappuccino to be prepared, you are recommended to
use whole milk at refrigerator temperature (not hot!).
Note: In choosing the size of jug, it is recommend the diameter is not less than 70±5mm, and bear in
mind that the milk increases in volume by 2 times, make sure the height of jug is enough.
、
4 Insert the frothing device into the milk about two centimetre, then turn the steam control knob slowly
in anti-clockwise, steam will come out from the frothing device. Froth milk in the way moving vessel
round from up to down.
Note: Never turn the steam control button rapidly, as the steam will accumulate rapidly in short time
which may increase the potential of the risk of explosion.
5. When the required purpose is reached, you can turn the steam control knob to the minimum position.
to the higher position which is the "
ON/OFF button
" position, waiting for a moment,
O FF
" position manually
position, waiting for until