Switching Your Highway On For The First Time; Switching Your Highway On And Off - PURE Highway 200 Manual

Switching your Highway on for the first time

After you've installed your Highway, switch it on to finish setting it up.
1. Turn on your vehicle's ignition to make sure your Highway is switched on.
2. Press and to change the display language, then press Select to choose it.
3. Press and Select to choose how to connect your Highway to your vehicle.
•
If you've connected your Highway with the Line Out cable, choose 'Line out'. Then press
'Normal gain'. If you later find that audio is distorted, you can change the gain setting. Read more on page 17.
•
If you're connecting your Highway by FM radio, choose 'FM transmit' and then choose an FM frequency. Ensure a
radio station isn't using the frequency you choose.
Tune your vehicle's audio system to the same FM frequency as your Highway. To easily find the FM
frequency in the future, save it as a preset on your vehicle's audio system.
After you've chosen how to connect your Highway, it starts tuning to digital radio stations. When the autotune is complete,
you can start listening to digital radio.

Switching your Highway on and off

•
To switch on your Highway, press .
•
To put your Highway in standby and use less power, press and hold .
Note: By default, the controller automatically enters standby after 4 hours. To change the delay, see page 17.
and Select to choose
13