Replace The Cover - HELVAR uSee Installation And Setup Manual

5: Replace cover and switch unit on
5.1:

Replace the cover

1. Tilt the cover so the front pegs locate in to the slots
and slide it forwards.
2. Push the bottom of the cover downwards and secure
it with the two retaining screws.
5.2: Switch on mains power supply and check operation
1. Switch on the mains power supply.
2. Check that 12 V power is being supplied: the PWR and HDD LEDs at the top of the unit should be on (PWR) and
flashing (HDD).
Diagram: HDD and PWR indicators Diagram: HDD and PWR indicators
With the unit powered on, you can now configure the uSee hub: see the next section for details.
Helvar uSee Installation and Set-Up Guide
9