Table of Contents
Advertisement
Maintenance
Please note: Depending in the type of maintenance or servicing to be undertaken a
variety of tools may be required. Included will be pozidriv screwdriver, 50mm spanner
(or suitable adjustable spanner) and small se of adjustable grooved joint pliers or
similar.
1. Carefully remove chrome plated service caps from above the service valves at either end of the
product. Lever the cap off using a flat screwdriver or similar, positioned in the ejection slots of
the cap - being careful not to damage the chrome.
2. Turn on the Bath and Shower Mixer using flow control lever, by rotating anti-clockwise, ensuring
that the tap is flowing.
3. Using service valve tool provided. (Spares Code 854464), locate in the castellations and rotate
clockwise to turn off water supply. BOTH sides hot and cold water to be turned off. Once tool is
located rotate until stop is reached. (Pegler Yorkshire recommend hot side first)
4. At this point the Bath and Shower Mixer has been isolated
of water
5. Rotate anti-clockwise the service valves inner using a
recommended 12mm socket drive spanner.
Please note: Ensure outer does not follow the inner - if
it does it will open the waterway again. If required, use a
flat screwdriver or similar and locate in castellations this
will help to hold in place the outer service valve body while
unscrewing the inner.
6. Once unscrewed; lift service valve inner assembly out of
the body (if a vacuum is making this difficult to remove,
grip on the flats of the hexagon with the end of a pair of
adjustable groove joint pliers and lift)
Please note: Ensure outer does not follow the inner - if it does it will open the waterway again. I
screwdriver or similar and locate in castellations this will help to hold in place the outer service v
unscrewing the inner.
7. After removing the service valve inner assemblies, they can be disassembled for cleaning or
replacing parts. The filter retaining cap can be removed by inserting edge of coin or similar and
simply twist.
1. Please note: If doing this, place the assembly on a hard, non slippery surface being careful
not to hurt yourself.
2. Once removed the parts can now been cleaned or left to soak. Descale using limescale remover,
Application
warm water or similar.
F
r o
B
a
h t
F
F
r o
S
h
o
w
r e
For Wash Basin
3. Using service valve tool provided. (Spares Code 854464), locate in the castellations and
turn off water supply. BOTH sides hot and cold water to be turned off. Once tool is locat
reached. (Pegler Yorkshire recommend hot side first)
4. At this point the Bath and Shower Mixer has been isolated of water
5. Rotate anti-clockwise the service valves inner using a recommended 12mm socket drive
Service Valve Inner
6. Once unscrewed; lift service valve inner assembly out of the body (if a vacuum is makin
remove, grip on the flats of the hexagon with the end of a pair of adjustable groove joint
Service Valve Inner
7. After removing the service valve inner assemblies, they can be disassembled for cleanin
The filter retaining cap can be removed by inserting edge of coin or similar and simply tw
Recommended Mixed Outlet
Application
Water Temperature °C
l l i
4
F
F
Insert edge of coin into
groove and twist, taking
care not to slip
Recommended Mixed Outlet
° 4
C
*
* *
9
r o
B
a
h t
F
l l i
4
° 1
C
41°C
r o
S
h
o
w
r e
Water Temperature °C
4
° 4
C
*
* *
4
° 1
C
Advertisement
Table of Contents
