Advertisement
Part 2 – Adjusting Clamp Height (Cont.)
If you are unable to close the clamp or only able to lock it in the highest position (one
click), you will need to adjust the clamp height. Otherwise, proceed to the next page.
Adjusting the clamp height:
Remove the clamp from the clamp housing.
•
Identify the two screws on the
•
inside, bottom portion of the
clamp, as shown at right.
Loosen and remove the screws
•
using a Phillips-head screw driver.
Once the screws are removed, gently separate the two pieces by
•
pulling apart.
Reposition the clamp at the higher location, as shown above.
•
Replace the screws and gently tighten. Completely tighten but do not
•
overtighten the screws. Overtightening may damage your RestoreX device.
Replace the clamp into the clamp housing.
•
Your RestoreX device is now customized for your use!
10
Instructions for Use
1-877-228-5147
Advertisement
