Buzzer And Led Settings - Baracoda RoadRunners Programming Manual

The following barcode should be used only when connecting the RoadRunners in batch mode to a Plug&Scan dongle.
Once the scanner is connected to the Plug&Scan dongle (user just need to read the paring barcode), this "Discarge
and Reset" barcode allows the scanner to discharge the data and to reset the Dongle (thus allowing a different
RoadRunners to connect to it). Please refer to the Plug&Scan RS232 or USB user guide for more information.
1.6

Buzzer and Led Settings

You can use this option to enable or disable the buzzer and / or the Led. You can also invert the led position.
LED CONFIG : default (*)
l eds : def aul t
\ V T \ V T \ F N C 4 \ S O \ N U L \ S O H \ N U L \ F F \ F F
LED CONFIG : inverted
l eds : i nv er t ed
\ V T \ V T \ F N C 4 \ S O \ N U L \ S O H \ S O H \ F F \ F F
Good read beep on
r ead beep ON
\ V T \ V T \ F N C 4 \ D C 4 \ N U L \ S O H \ F N C 4 " \ F F \ F F
Good read beep off
r ead beep OFF
\ V T \ V T \ F N C 4 \ D C 4 \ N U L \ S O H \ F N C 4
Beep level Volume = LOW
beep l ev el : l ow
\ V T \ V T \ F N C 4 \ D C 4 \ N U L \ S O H \ F N C 4 @\ F F \ F F
© Baracoda 2005
RoadRunners Linear CMOS Programming guide (Oct. 05)
Discharge and Reset Baracode
(to use only when the RoadRunners is
connected to a Plug&Scan Dongle)
Di schar ge and Reset
\ V T \ V T \ F N C 4 r \ N U L \ N U L \ F F \ F F
\ F F \ F F
LED ON (*)
l eds on
\ V T \ V T \ F N C 4 \ E OT \ N U L \ S OH \ F N C 4 \ S OH \ F F \ F F
LED OFF
l eds of f
\ V T \ V T \ F N C 4 \ E OT \ N U L \ S OH \ F N C 4 \ N U L \ F F \ F F
ACK beep on
ACK beep ON
\ V T \ V T \ F N C 4 \ D C 4 \ N U L \ S O H d \ F F \ F F
ACK beep off
ACK beep of f
\ V T \ V T \ F N C 4 \ D C 4 \ N U L \ S O H b \ F F \ F F
Beep level volume = HIGH
beep l ev el : hi gh
\ V T \ V T \ F N C 4 \ D C 4 \ N U L \ S O H \ F N C 4 A \ F F \ F F
7/24