Baracoda RoadRunners Programming Manual page 5

NO
Programming procedure for "set Timestamp" option.
Set Timestamp
Set Ti m es t am p
\ V T \ V T \ F N C 4 t \ N U L \ N U L \ L F \ L F
Note that the timestamp must fit the specific following format:
{YY} {MM} {DD} {HH} {MM} {SS}
The setting is made by scanning the 0-9 labels (Appendix 1) as on a calculator; following the timestamp
format shown above.
For example: to set the current time at 16th May 2007, 3.25 pm, the user will scan:
- "Set Timestamp" label,
- "0" label,
- "7" label,
- "0" label,
- "5" label,
- "1" label,
- "6" label,
- "1" label,
- "5" label,
- "2" label,
- "5" label,
- "0" label,
- "0" label,
- "end of config" label.
© Baracoda 2005
RoadRunners Linear CMOS Programming guide (Oct. 05)
START
Read « Set Timestamp » label
Read intermediary label
Corresponding to the next digit to set for the
Timestamp (from Appendix 1)
Finished ? (1)
YES
Read « END of config » label
END
END of config
END of Conf i g
\ L F \ L F E N D \ F F \ F F
4/24