Advertisement
1: With the display brackets attached to the display, lift and place the brackets on to the
2: Center the display from left to right on the mounting plate.
3: Screw the 1/4-20 screw (10) into the locking plate (13)
4: Place the locking tab assembly into the slots on the display bracket, and tighten the 1/4-20 screw (10) on each locking tab assembly. SEE FIG 5
Fig 4
MOUNTING PLATE
Adjust by tightening the tension bolts to suit the desired freedom of movement See fig 6
1: Lift the tie holder(16) on the lock tab to allow access the bolt to adjust the tension on the arm center. Replace the tie holder (16) after adjustment.
3: Two other tension bolts can be tightened or loosened to suit. SEE FIG 6
2: Adjust the tilt by loosening the Tri knob on the side of the AWM125-120 and adjust back or forward for best viewing angle. See fig 6
3: Place the plastic tie holders (16) in the desired holes, and using zip ties (14) attach the cables.
4: Make sure you articulate the mount from side to side looking for any pinching of the cables.
Fig 6
3. Mounting the display onto the AWM125-120 Articulating arm
DISPLAY BRACKETS
TRI KNOB
LOCKING TAB ASSEMBLY
3. Final adjustment and cable management
TENSION BOLTS
CABLE
mounting plate
Fig 5
SCREW LOCK TAB
6
in either the top middle or bottom slots. SEE FIG 4
large view
1/4-20 screw
NYLON ZIP TIE
TENSION ADJUSTMENT BOLT
Advertisement
