Advertisement
INSTALLATION LOCATION
The wall where the wall mount is to
the panel display and wall mount. Measures should al
withstand the force of earthquakes,
Note: Incorrect installation can cause the
INSTALLATION ON A WOODEN WALL
Always install so that the load is supported by a wood stud. If
Do not install on decorative posts or plaster board.
Avoid installing in locations where the temperature and humidity are excessively high, and where contact with any
water is possible. These can result in fire or electric shock.
Do not install close to an air conditioner intake or outlet. Do
oily smoke or tobacco smoke. Fire could result.
Do not block the ventilation holes. Leave sufficient clearance in regard to the surroundings to avoid blocking the ventilation.
The internal temperature could elevate and possibly result in fire. Install the panel (4") or more away from surroundings.
.
Install only on a vertical surface. Avoid
elevate and possibly result in fire. Injury or damage could also result from falling.
Do not install in locations where there is excessive vibration or impact. Injury and damage could result from the panel display
falling.
Do not install where there is direct sunlight or other strong
Use the specified bolts and screws in the specified places and tighten firmly. Failure to do this could cause injury if the panel
display falls.
Do not alter any of the parts. Do not use broken parts. This
Always use at least two people to perform the installation work. Injury could result from dropping heavy objects.
C a u t i o n : I n s t a l l a t i o n o f u n i t i s t o b e c a r r i e d o u t b y q u a l i f i e d t e c h n i c i a n s o n l y . I n s t a l l i n a n a p p r o p r i a t e
l o c a t i o n b y c h e c k i n g t h e w a l l s t r u c t u r e a n d d u r a b i l i t y f o r s a f e t y a n d a c c i d e n t p r e v e n t i o n .
Rev 100708
WARNING
be installed must be capable of long-term support of the total load of
vibration and other external forces.
panel display to fall and cause injury.
Total load ( panel display + mount )
MAXIMUM WEIGHT= 125 Lbs. ( 57 Kg.)
the strength of the wood studs is not sufficient, add reinforcement.
Always confirm the center of the stud is used for the installation.
CAUTION
sloped surfaces. Also, do not install facing upward. The internal temperature could
WARNING
so be taken to ensure sufficient strength to
not install in locations where there are excessive amounts of dust,
light. Strong light could result in eye fatigue during usage.
could result with injury due to the panel display falling.
2
.
Advertisement
